Agilent Technologies Turbo-V 1000 HT Notice De Mode D'emploi page 275

Startup
1
2
R
S
The controller with the Soft Start mode allows the pump to ramp-up
to Normal Speed slowly with a minimum ramp-up time of 30 minutes
and a maximum of about 55 minutes. The Soft Start mode is always
operative as default mode. If it is necessary to deselect this mode
refer to the following paragraph. If the Soft Start mode is deselected,
the ramp- up will be done within 300 seconds and the display
changes as follows:
P
If the pump is not connected, the display will be as shown:
NOTE
C
After pressing the START push-button, if the P1 connector is not in place with
NOTE
the link or the external interlock connection are open, the display will be as
shown in the following figure. Unplug the controller power cable and verify the
P1 connection according to section II.
P
I
Turbo-V 1000HT Controller User Manual / 87-900-894-01
Plug the controller power cable into a suitable power source.
The display lights, and shows:
E A D Y
O F T
U M P
S T A R
H E C K
T O
U M P W
N T E R
F O R
S T A R T
R E A D Y
T B U T
C O N N
P U M P
A I T I
L O C K
(G)
Technical Information
Use
L O C A
: P U
T O N
E C T I
N G
275/310
17
L
S H
O N