Agilent Technologies Turbo-V 1000 HT Notice De Mode D'emploi page 254

17 Technical Information
Optional Serial Port
RS 232 Communication Port
Communication serial port connections and mini- mum connection
configuration are shown in the following figures. The communication
port mating connector is supplied with the RS 232 PCB
(AMP/Cannon or equivalent 9-pin "D" type male connector). The
external cable (not supplied) between the host computer and the
controller requires some crossed wires so that signals are connected
correctly.
For example, the Transmit data signal from controller (pin 2) must
be connected to the host computer's Receive data line (pin 3) and
vice versa. Consult the host computer's instruction manual for its
serial port connections.
Agilent cannot guarantee compliance with FCC regulations for radiated
NOTE
emissions unless all external wiring is shielded, with the shield being
terminated to the metal shroud on the O-subconnector. The cable should be
secured to the connector with screws.
254/310 Turbo-V 1000HT Controller User Manual / 87-900-894-01 (G)