Agilent Technologies Turbo-V 1000 HT Notice De Mode D'emploi page 243

Fuse Holder and Voltage Changer Assembly
The following figure shows the location of this assembly.
Figure 6
Proceed as follows to replace one or both fuses:
1
2
Turbo-V 1000HT Controller User Manual / 87-900-894-01
Rear panel
Remove the assembly by levering in position A with a small
screwdriver.
Replace the fuse.
Use only T-type fuses of the following characteristics:
100/120 Vac 6.3 A
220/240 Vac 3.15 A
Fuse Holder and Voltage Changer Assembly
(G)
Technical Information
243/310
17