Table des Matières
Publicité
[6]. Briefly press the PROG button at the back of the monitor (above the battery housing).
- The indicator light on the receiver flashes for 5 seconds.
[3]
2 mn
2 s
[7]. Return the monitor to its rear section (see 3.1 General information, page 5).
Note: To clear the video entry phone programming on a Somfy light receiver, repeat all the steps detailed above.
3.5 Programming a Somfy RTS gate motorisation
[1]. Remove the monitor from its rear section (see 3.1 General information, page 5).
[2]. Open the cover on the control cabinet or the motor containing the electronics.
[3]. Check that the motor is powered on.
[4]. Select the desired channel by pressing the channel selection button on the monitor.
[5]. Place the monitor on the target on the motor electronic unit.
Important: The le -hand section of the monitor must be placed on the electronic unit target so that the monitor can be
correctly detected by the motor electronics.
[6]. Briefly press the monitor opening button.
- The RADIO indicator lights on the motor electronic unit lights up then goes out.
[4]
1..2..3..4..5
[7]. Close the cover on the control cabinet or the motor.
[8]. Return the monitor to its rear section (see 3.1 General information, page 5).
Note: To clear the video entry phone programming on a Somfy gate motorisation, see the motorisation guide.
[1]. Select the desired channel.
[2]. Press
to open the relative product (roller shutter, awning, garage door, etc.) or to switch the light on.
[3]. Press
to close the relative product or to switch the light off.
[4]. Press
to:
- stop the relative product currently being moved.
- reach the favourite position if programmed.
4.1 Saving or modifying the favourite position
When the relative product is moving:
[1]. Stop the product in the desired position
[2]. Press
for 5 seconds.
Copyright © 2016 Somfy SAS. All rights reserved.
[4]
2s
1..2..3..4..5
[5]
4 USING THE RTS MONITOR CONTROL
[5]
< 0,5s
EN
5 s
5 s
8
Publicité
Chapitres
Table des Matières
