Diagnosis, Alarms And Inconveniences; Diagnosis Of The Inconveniences; Functional Aspects Not To Be Mistaken For Anomalies; Console Led Signals - Olimpia splendid Unico Edge R32 Mode D'emploi Et D'entretien

4.3 - DIAGNOSIS, ALARMS AND INCONVENIENCES

4.3.1 - Diagnosis of the inconveniences

It is important for the User to distinguish between functional problems and anomalies in relation to the behaviour
of the appliance as foreseen for its normal operation. Furthermore, the most common problems may easily
be solved through simple operations on behalf of the User (See paragraph 4.3.5 - Anomalies and solutions).
For all the other reports (see paragraph: 4.3.3 - 4.3.4), it is necessary to always
contact the technical assistance service"
Any attempt to repair the appliance by unauthorised personnel will immediately
invalidate any form of guarantee.

4.3.2 - Functional aspects not to be mistaken for anomalies

The following events may occur during normal operation:
a. The compressor does not start up again immediately after a stop (it takes about three minutes
to start again).
- In the operating logic of the appliance a delay between a compressor stop and its successive restart
has been included, so that the compressor itself is protected against activations that are too frequent.
b. During the heating operation of the heat pump appliances, the flow of hot air may occur some
minutes after activation of the compressor.
- Should the fan start at the same time as the compressor, for the first few minutes it would emit cold
air into the room (and this could bother the occupants) since the unit has not yet reached steady
running conditions.

4.3.3 - Console led signals

In the event that the air conditioner is blocked, the LEDs
highlight an alarm signal as per table "TAB1".
Contact an Olimpia service centre.
H Reset key.
G Infrared receiver.
EN - 34
G LED D LED B
LED C LED A
H
50