Publicité
Les langues disponibles
Les langues disponibles
CARRYING STRAP
The accessory carrying strap can be attached to fixing points ,o
on either side of the recorder. The strap can be adjusted to the
desired length by means of the clasp.
ERASING WITHOUT RECORDING
A recording can be erased from the tape without a new recording
being added. To do this:
• Insert a plug of the connecting cable into socket ,z in order to
switch off the built-in microphone.
• Press the record key ® and start key ® at the same time.
• To stop, press the stop key
SAFEGUARD AGAINST ACCIDENTAL ERASURE
You can prevent the accidental erasure of your recordings, some
of which will hold great value for you, in the following way. With a
screwdriver or other suitable object, break out the little fl ap on the
back of the cassette opposite the 2 (for a recording on side 1) or
that opposite the 1 (for a recording on side 2) - Fig. 7.
Thereafter, with the cassette in the recorder, the record key ®
cannot be depressed, in consequence of which the cassette can
only be played back.
MAINTENANCE
In normal circumstances your recorder will require no special at-
tention in the way of maintenance. It is recommended however, to
remove after every 50 hours of operation the oxide dust which has
collected on and around the magnetic heads. For this purpose, our
cleaning tape, type 811 /CCT, must be used.
Furthermore, it is a good plan to have your dealer examine the re-
corder perhaps once a year or after every 500 hours of operation.
Then, the equipment can be cleaned, checked and adjusted
where necessary, and parts subject to wear can be replaced in
good time.
Notes:
1. Excessive heat being bad for the recorder, batteries and cas-
settes alike, ensure that they are not exposed to direct sunshine
for any great length of time.
2. Keep the recorder away from sand, for the mechanism can be
damaged should sand get into it.
3. The driving mechanism must not be lubricated!
11
Publicité
