MINN KOTA RIPTIDE MAXXUM Manuel Du Propriétaire page 9

2
c. Open the mount by lifting the Upper Arm up and
opening the mount so it lays flat.
WARNING
Carefully lower the Bowguard into place to avoid creating a
pinch point between the Bowguard and Mount.
d. Align the Lower Arm and the Lower Bowguard Ears.
Once aligned, insert the Lower Pin, pushing it
through both the Lower Arm and the Bowguard Ears.
e. Re-install the E-Clips into the Lower Pin.
f. Take the Rope and route it under the Lower Pin and
through the bottom of the Eyelet and out the top of
the Bowguard.
3
g. Rotate the Upper Arm back in place to close the
mount.
h. Align the Upper Arm Holes with Upper Bowguard
NOTICE:
The two Bushings in the Upper Arm may
come out. Re-assemble them into the Upper Arm
making sure the "keys" of the inserts are aligned
with the "key" punchouts in the Upper Arm.
Ears and install the Upper Pin.
i. Re-install the Washer and Nylock Nut and tighten
using two 1/2" Wrenches.
4
j. Route the Rope through the Pull Grip Handle and
small Washer. Secure it by tying a Figure Eight Knot.
©2021 Johnson Outdoors Marine Electronics, Inc.
All manuals and user guides at all-guides.com
Bouguard Bouguard
Lower Lower
Bowguard Bowguard
Lower Lower
Ears Ears
Arm Arm
E-Clip E-Clip
Lower Pin Lower Pin
Upper Arm Upper Arm
Bushing Bushing
Washer Washer
Nylock Nut Nylock Nut
Pull Grip Handle Pull Grip Handle
Figure Eight Figure Eight
Knot Knot
INSTALLATION
Eyelet Eyelet
Rope Rope
Lower Lower
Bouguard Bouguard
Ears Ears
Bowguard Bowguard
Washer Washer
minnkotamotors.com | 9