Publicité
Les langues disponibles
Les langues disponibles
Installation of the Hold Down Strap
The Hold Down Strap is not included on all models.
1
a.
Before mounting the trolling motor place the Hold
Down Strap under the Bow-mount between the
Mounting Holes near the back of the motor rest with
the hook and loop side of the strap facing down.
b.
Secure the Bow-mount with the Mounting Bolts
to capture the Hold Down Strap as noted in
the Installation of the Bow-mount Section of
this Manual.
c.
To secure, stow the motor, and then pull the Hold
Down Strap through the rectangular Ring until snug.
Press the hook pad of the strap, into the loop pad
and secure. The Hold Down Strap should be used
whenever the motor is stowed.
WARNING
When the motor is being transported, on water or land, it
is important to place the motor completely out of water.
The motor should be positioned up close to the Bowguard.
The motor should be positioned on the Rails of the Motor
Rest and in the stowed position. Release the Depth Collar
and slide it along the Shaft until it makes contact with
the Bowguard, then re-secure the Depth Collar. For added
security during transport secure the Hold Down Strap. This
provides a secure stow and holds the motor in place during
transportation when it is subject to high levels of shock and
vibration. Failure to secure the motor may result in injury or
damage to the unit.
©2021 Johnson Outdoors Marine Electronics, Inc.
All manuals and user guides at all-guides.com
1a
Bow-Mount
Bow-Mount
Mounting
Mounting
Holes
Holes
Ring
Ring
INSTALLATION
Bow
Bow
Hold Down
Hold Down
Strap
Strap
Hold Down
Hold Down
Strap
Strap
minnkotamotors.com | 11
Publicité
