MINN KOTA RIPTIDE MAXXUM Manuel Du Propriétaire page 8

TOOLS AND RESOURCES REQUIRED
• (2) 1/2" Wrenches
• 9/32" Drill Bit
INSTALLATION
INSTALLATION OF MOTOR TO MOUNT
1
WARNING
Make sure that the Power Cables from the battery are
disconnected, or that the breaker, if equipped, is "off."
a. With the Mount closed, use two 1/2" Wrenches to
remove one of the two Nylock Nuts and Washers from
the Upper Pin. Then remove the Pin from Mount.
NOTICE:
The two Bushings in the Upper Arm may
come out. If so, keep them for re-assembly.
b. Using a pair of Pliers, remove the Spring Clip from
the Lower Pin. Remove the Lower Pin from Mount.
NOTICE:
This motor weighs approximately 60 lbs.
We recommend having a second person help with
the installation.
8 | minnkotamotors.com
All manuals and user guides at all-guides.com
INSTALLATION
• A second person to help
with the installation
• Standard or Needle Nose Pliers
• File or Sandpaper
Upper Upper
Arm Arm
• Hand Saw
• 3/8" Nut Driver
Nylock Nuts Nylock Nuts
& Washers & Washers
Bushing Bushing
Upper Pin Upper Pin
E-Clip E-Clip
Lower Pin Lower Pin
©2021 Johnson Outdoors Marine Electronics, Inc.
Mount Mount
Bushing Bushing