Care And Cleaning; Troubleshooting - Zanussi ZDT16017FA Notice D'utilisation

• The cap of the salt container is tight.

Care and cleaning

Warning! Before maintenance,
deactivate the appliance and disconnect
the mains plug from the mains socket.
Dirty filters and clogged spray arms de-
crease the washing results.
Make a check regularly and, if necessary,
clean them.
Cleaning the filters
1
3
5

Troubleshooting

The appliance does not start or it stops during
operation.
24
C
B
A
2
4
D
6
7
To remove filters (B) and (C), turn the handle
counterclockwise and remove. Pull apart filter
(B) and (C). Wash the filters with water.
Remove filter (A). Wash the filter with water.
Before you put the filter (A) back, make sure
that there are no residues of food or soil in or
around the edge of the sump.
Make sure that filter (A) is correctly positioned
under the 2 guides (D).
Assemble filters (B) and (C). Put them back in
filter (A). Turn the handle clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and damage
to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin poin-
ted object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Before you contact the Service, refer to the in-
formation that follows for a solution to the
problem.
8
www.zanussi.com