Troubleshooting - Zanussi ZDF12001WA Notice D'utilisation

3
5
7
To remove filters (B) and (C), turn the handle
counterclockwise and remove. Pull apart filter
(B) and (C). Wash the filters with water.

Troubleshooting

The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the prob-
lem.
Alarm code
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittently.
www.zanussi.com
4
D
6
8
Remove filter (A). Wash the filter with water.
Before you put the filter (A) back, make sure
that there are no residues of food or soil in or
around the edge of the sump.
Make sure that filter (A) is correctly positioned
under the 2 guides (D).
Assemble filters (B) and (C). Put them back in
filter (A). Turn the handle clockwise until it locks.
An incorrect position of the filters can
cause bad washing results and damage to
the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin pointed
object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Internal cleaning
If you regularly use short duration programmes,
these can leave deposits of grease and lime-
scale inside the appliance.
To prevent this, we recommend to run long du-
ration programmes at least 2 times per month.
With some problems, different indicators
flash continuously or intermittently at the
same time to show an alarm code.
Problem
The appliance does not fill with water.
The appliance does not drain the water.
33