Publicité
Les langues disponibles
Les langues disponibles
21) MAXI.VOLTAGE PROTECTION LIMIT
Set
the MAXIMUM LIMIT of VOLTAGE PROTECTION.
Long Press PUSH key (4) to
enter
1.
Turn the CH rotary knob (4) or use UP/DN keys (19) on the microphone to
select
the VOLT PROTECTION menu.
2.
Press PUSH key (4) to
validate.
3.
Turn the CH rotary knob (4) or use the UP/DN keys (19) on the microphone
to
select
9. 0 to 16. 0 .
4.
Short press the PUSH key (4) to validate. a) Return to the point 1 to set another
menu or b) Short press the PTT key (18) to
disappears from the display.
5.
exits
If no key is pressed, the unit
from the display.
Default value is 16. 0
22) RESET
Erase
This function allows to
settings.
Long Press PUSH key (4) to
enter
1.
Turn the CH rotary knob (4) or use UP/DN keys (19) on the microphone to
select
the RESET menu.
2.
Press PUSH key (4) to
validate.
3.
Turn the CH rotary knob (4) or use the UP/DN keys (19) on the microphone
to
select
SC or AL.
4.
Short press the PUSH key (4) to validate. a) Return to the point 1 to set another
menu or b) Short press the PTT key (18) to
disappears from the display.
5.
exits
If no key is pressed, the unit
from the display.
SC erase all the channels stored on the SCAN SKIP memory. They are now
enabled to be scanned (see the § SKIP page 9).
AL restore all the factory parameters.
E) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Weather channels
the MENU.
is displayed.
The current value blinks on the display.
validate
and
exit
the MENU.
MENU after 10 seconds.
disappears
restore
the scan skip memory or
the MENU.
is displayed.
The current value blinks on the display.
validate
exit
the MENU.
and
MENU after 10 seconds.
disappears
: 40
: AM / FM / USB / LSB
: from 26.965 MHz to 27.405 MHz
: from 162.400 MHz to 162.550 MHz
- Antenna impedance
- Power supply
- Dimensions (W x D x H)
- Weight
- Accessories supplied
2)
TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity
- Drain
- Modulated signal distortion
all factory
3)
RECEPTION
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
F) TROUBLE SHOOTING
1) YOUR RADIO WILL NOT TRANSMIT OR YOUR TRANSMISSION
IS OF POOR QUALITY
-
Check that the antenna is correctly connected and that the SWR is properly
adjusted.
-
Check that the microphone is properly plugged in.
-
You are using the same modulation mode than your correspondent.
17
: 50 ohms
: 13.8 V
: 7.28 x 6.77 x 2.20 inches
185 x 172 x 56 mm
: 2.204 lbs / 1.190 kg
: 1 microphone electret UP/DOWN with
support, mounting cradle, screws and
fused power cord.
: +/- 200 Hz
: 4 W AM / 4 W FM / 12 W PEP USB LSB
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz
: 3.0 mV
: < 5 A max. with modulation (13.8 V)
: 2 %
: 0.5 µV - 113 dBm (AM)
0.35 µV - 116 dBm (FM)
0.28 µV - 118 dBm (USB/LSB)
: 300 Hz to 3 kHz in AM/FM
: 60 dB
: 3 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 200 ~ 600 mA maximum (13.8 V)
Publicité
