HYDAC ELECTRONIC EDS 1700 Mode D'emploi page 39

All manuals and user guides at all-guides.com
8.2. ALTERING THE HARDWARE PROGRAMMING ENABLE
 Disconnect the unit from the supply voltage.
 Remove the 4 screws from the unit front panel (Illustration 1).
 Lift front panel off carefully and put to one side.
 Push slide switch on the lower board to the required position (Illustration 2):
EN
"OFF": programming disabled.
 Replace front panel on the unit and screw into position, ensuring that the
front panel seal is in the correct position.
9. Altering the mounting position
 Disconnect the unit from the supply voltage.
 Remove the 4 screws from the front plate of the unit (Illustration 1).
 Carefully lift off the front panel and turn through 180°.
 Replace the front panel on the unit and screw into position, ensuring that the
front panel seal is in the correct position (Illustration 2).
32
Illustration 1
pressure connection
Illustration 1
programming
possible
disable
Illustration 2
Illustration 2
pressure connection