HYDAC ELECTRONIC EDS 1700 Mode D'emploi page 28

All manuals and user guides at all-guides.com
3. Operating keys on the membrane keypad
keys for setting the switching points
and additional functions
4. Digital display
After switching on the supply voltage, the unit briefly displays "EdS" and then
displays the current pressure.
Notes:
 In the basic settings the display can be altered so that, once switched on,
the unit displays a switching point or the maximum value permanently. In
this case "S.P. 1", "S.P. 2", "S.P. 3", "S.P. 4", or "MAX" appears briefly on
the display following the switch-on message. The current pressure can be
displayed briefly by pressing the "+" or "-" key.
 If the current pressure exceeds the nominal pressure of the unit, it can no
longer be displayed and the display begins to flash.
 If the current pressure is below 0.5% of the nominal range, then 0 is
displayed.
undo screws to remove
operating panel
4-digit
digital display
EN
23