Stihl MS 271 Notice D'emploi page 26

English
► Pull the starter grip slowly with your right hand
until you feel it engage – and then give it a
brisk strong pull and push down the front han‐
dle at the same time. Do not pull out the
starter rope to full length – it might otherwise
break. Do not let the starter grip snap back.
Guide it slowly back into the housing so that
the starter rope can rewind properly.
Machines without additional manual fuel pump: If
the engine is new or after a long out-of-service
period, it may be necessary to pull the starter
rope several times to prime the fuel system.
16.6.2 Versions with Easy2Start
The Easy2Start stores the energy required to
start the saw. For this reason there may be a
delay of a few seconds between cranking the
engine and it actually starting.
There are two ways of starting machines with
Easy2Start:
► Hold the starter grip with your right hand and
pull it out slowly and steadily – or – hold the
starter grip with your right hand and give it
several short pulls, using only a short length of
rope for each pull.
► Push down the handle while cranking. Do not
pull out the rope to its full length – it might oth‐
erwise break.
► Do not let the starter grip snap back. Guide it
slowly back into the housing so that the starter
rope can rewind properly.
16.7 Starting the Saw
WARNING
Bystanders must be well clear of the general
work area of the saw.
16.7.1 Versions with manual fuel pump
► Press the manual fuel pump bulb at least five
times – even if the bulb is already filled with
fuel.
26
16 Starting / Stopping the Engine
16.7.2 All models
1
► Push the hand guard (1) forward – the chain is
locked.
► Press down the trigger lockout (2) and pull the
throttle trigger (3) at the same time. Set Mas‐
ter Control lever (4) to:
Choke shutter closed (l)
– If the engine is cold (also use this position if
the engine stopped when you opened the
throttle after starting)
Starting throttle position (n)
– If the engine is warm, i.e. if it has been running
for about one minute.
► Hold and start your saw as described.
16.8 When engine begins to fire
4
► Set the Master Control lever (4) to the starting
throttle position (n).
► Hold and start your saw as described.
4
2
4
3
4
0458-574-8221-D