Create WIND RATTAN Mode D'emploi page 9

• Mark the correct position of the holes and fix the ceiling bracket using the screws with
metal anchors or screws and washers appropriate to the type of ceiling chosen.
• Check the correct installation of the bracket before hanging the fan. This plate must sup-
port the entire weight of the fan.
INSTAL L ATION PRE PAR AT I O N
• To avoid personal injury and injury, make sure that the place where you are going to hang
the fan allows the blades to be 2.3 m or more from the ground and 76 cm from the nearest
wall or obstacle.
• Make sure the junction box is adequately fastened to the building structure and can sup-
port the full weight of the fan.
SITE PR E PAR ATI ON
• Choose the suspension bar that best suits your situation.
• Remove the bolt from the bar by removing the pin and thread the canopy (roof trim) and
motor canopy through the hanger bar. Next, route the fan motor wires through the inside of
the hanger bar. Fit the hanger bar to the engine and insert the bolt and cotter pin.
Traditional
mounting
style
The traditional mount hangs from the ceil-
ing with a bar.
INSTALLATION INSTRUCTIONS
76cm
2.3m
Support
76cm
20° 20°
Angle mount style
Angle mounting is recommended on sloped
or vaulted ceilings.
Support
E NGLI SH
9