Create WIND RATTAN Mode D'emploi page 10

IN STAL LIN G THE MOU NT I NG B R ACKE T
Before installing the mounting bracket you should check the ceiling where the fan is to be
installed and check if it is suitable for it.
Concrete ceiling
Drill 2 holes with an 8mm drill bit, accord-
ing to the length of the expansion bolts.
Next, fix the mounting bracket to the ceil-
ing with the screws.
Do not fix the mounting bracket directly on ceilings less than 10mm to avoid the risk of the
screw loosening and coming out.
M OU NT I NG AN D HANGING O F T H E FAN
Lock pin
Before you begin mounting the fan, you must choose the appropriate height for your home.
If you want to extend the hanging length of your fan, remove the hanger bar ball and use the
additional extension bar (included).
1. To remove the hanger ball loosen the set screw and remove the pins.
2. Lower the ball and remove the locking pin.
3. Take out the hanger rod ball and insert it into the longer hanger rod (the top of the rod has
a fixing screw hole, please use it to fix the rod).
4. Insert the locking pin into the end of the suspension rod and raise the ball.
5. Finally make sure that the locking pin is aligned with the slots inside the ball and fix the
set screw.
E NGL I SH
10
Attach the mounting bracket to the wood
ceiling with 4 minimum 7mm thick screws.
Barrette
lock
Wood roof
Cabling
Bar of
suspension
Rosette
Trim
Cap screw
Adapter
Fixing screw