Create WIND RATTAN Mode D'emploi page 12

LIG HT PAN E L MOU NT ING
1. I unscrew the fixing screws of the motor.
NOTE: While installing or removing the light panel, carefully keep the insulation pads intact.
Turning the fixing screws too tight or too fast will damage the insulating pads.
3. Then connect the led board wires and put
the led board into the light panel. This
plate is magnetized, you should not put
any fixing tool.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances
in electric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on
the package indicates that the product at the end of its service life shall be collected as separate waste. Therefore,
any products that have reached the end of their useful life must be given to waste disposal centres specialising in
separate collection of waste electrical and electronic equipment, or given back to the retailer at the time of purchas-
ing new similar equipment, on a one for one basis. The adequate separate collection for the subsequent start-up
of the equipment sent to be recycled, treated and disposed of in an environmentally compatible way contributes to
preventing possible negative effects on the environment and health and optimises the recycling and reuse of compo-
nents making up the apparatus. Abusive disposal of the product by the user involves application of the administrative
sanctions according to the laws.
E NGL I SH
12
2. Fix the light panel to the bottom of the
motor body by fastening it with the fixing
screws, matching the holes in the panel
with the slots in the holes in the motor.
4. Attach the light trim plate by screwing it
in a clockwise direction and your fan is
fully installed.