Télécharger Imprimer la page

Bodet Profil 750 Manuel D'installation Et De Mise En Service page 43

Masquer les pouces Voir aussi pour Profil 750:

Publicité

Les langues disponibles

Les langues disponibles

Reconnect the flat cable (identified as B)
14
going to the movement on this face (limit
its length using the cable clip).
Before replacing the clock's face on the
15
grommet side, proceed with the clock's
internal cabling. Refer to the following
chapters of this manual according to your
model.
If
subsequent
required, remove only the clock's
face on the grommet side.
Access to the battery (optional)
requires removal of the face opposite
the grommet.
Once the clock has been wired, clean the
16
seal on the clock's face on the grommet
side, then apply silicone oil on it.
Realign this face and reconnect the flat
17
cable (identified as A) from the electronic
card to the movement located on the
disassembled face.
Limit the length of the cable by running
18
it through the cable clip in order to avoid
shading in the case of the lighting option
(contact of the cable with the dial once the
clock is closed).
Close the clock by replacing the
19
disassembled face back into its original
position.
Tighten the four cover screws (1.2 Nm)
20
on the newly reassembled clock face.
Replace and tighten the air inlet screw
21
(15 Nm) located beneath the bracket arm.
2.2.1.2 Mounting with IP65 sealing plate (optional)
Unscrew and remove the air inlet screw
1
located beneath the bracket arm.
(6 mm Allen key, tightening torque: 15 Nm)
Partially unscrew the four cover screws
2
on one clock's face. (3 mm Allen key,
tightening torque: 1.2 Nm)
Carefully slide open and partially separate
3
this clock face to access the clock's
internal cabling.
Disconnect the flat cable connected to the
4
movement on both clock faces.
Remove the first clock face completely
5
and place it on a straight, clean and
uncluttered work surface.
Partially unscrew the four cover screws
6
of the second face, remove this face and
place it on a straight, clean and uncluttered
work surface.
maintenance
is
A2
B2
(mm)
P750
A2
153
B2
423
C2
216
D2
540
E2
70
F2
100
G2
150
H2
74
I2
34
X8
EN
I2
H2
D2
F2
C2
P760
P780
150
160
470
580
216
218
640
840
70
70
100
100
150
150
74
74
34
34
43

Publicité

loading

Ce manuel est également adapté pour:

Profil 760Profil 780