Publicité
Les langues disponibles
Les langues disponibles
2.2 Double-sided clock
2.2.1 Mechanical installation
This double-sided clock can weigh up to 28 kg. It is important to take into account
mechanical stresses involved in locking, which is why we recommend installing
this double-sided clock preferably on a concrete wall.
The double-sided clock must be previously opened before being installed.
Follow the steps below to proceed with the mechanical installation of the clock.
2.2.1.1 Standard mounting
Unscrew and remove the air inlet screw
1
located beneath the bracket arm.
(6 mm Allen key, tightening torque: 15 Nm)
Partially unscrew the four cover screws
2
on one clock's face.
(3 mm Allen key, tightening torque: 1.2 Nm)
Carefully slide open and partially separate
3
this clock face to access the clock's
internal cabling.
Disconnect the flat cable connected to
4
the movement on both clock faces.
Remove the first face completely and
5
place it on a straight, clean and uncluttered
work surface.
Partially unscrew the four cover screws
6
of the second face, then remove this
face and place it on a straight, clean and
uncluttered work surface.
Remove the cardboard wedge between
7
the movement and the dial.
Where the clock is to be installed:
8
drill 4 holes according to the layout and
dimensions indicated below for fixing the
bracket.
In the case of a standard mounting on a
9
concrete wall, insert the wall plugs into
the drilled holes.
Run the cable through the clock's bracket
10
arm.
Place the bracket in position and tighten
11
the wall fixing screws.
It is recommended to apply a silicone
seal between the plate and the wall to
ensure correct sealing.
Replace the face of the clock opposite
12
the grommet after first cleaning the seal
of this face and applying silicone oil on it.
Tighten the four cover screws (1.2 Nm)
13
on this clock face.
42
X8
Ø 8 mm
X8
EN
E 2
Publicité
