Bodet Profil 750 Manuel D'installation Et De Mise En Service page 40

2.1.2 Electrical installation
There are two versions of NTP clocks: PoE or 230V
Refer to the product label to determine which version you have.
The lighting (if this option has been selected) is always powered via a mains power supply.
However, the power supply of the electronic card may vary depending on your model:
NTP PoE model: the power supply of the card is provided via the Ethernet cable,
NTP 230V model: the power supply of the card is provided via a second power supply (15V)
connected to the mains.
2.1.2.1 NTP 230V model
Run a mains cable through the right-
1
hand cable gland then connect this
cable to the terminal block in the
L-N- terminals dedicated to the
electronic card (icon
has the lighting option, the 2 mains
cables must come from the same
building.
2 Connect this mains cable to the
plate with a cable retainer.
Run the Ethernet cable through the
3
smallest central cable gland.
4 Crimp the RJ45 male plug onto this
cable only once it has been run
through the clock, and check the
crimping using a network tester.
5 Connect this cable to the electronic
card via the Ethernet port.
Connect the backup battery cable (if
6
available) to the electronic card.
40
). If the clock
.
Ethernet cable
Ø 1,5 mm
2
230 V
EN
NTP