LawnMaster GT1415 Guide D'utilisation page 4

14" dual line grass trimmer
Masquer les pouces Voir aussi pour GT1415:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GENERAL SAFETY RULES
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR GRASS TRIMMER
• Do not expose to moisture.
• Use only on AC mains supply voltage shown on the product rating label.
• Avoid operating your trimmer in wet grass, where feasible.
• Take care in wet grass, you may lose your footing.
• On slopes, be extra careful of your footing and wear nonslip footwear.
• Do not walk backwards when trimming, you could trip. Walk never run.
• Switch off before pushing the trimmer over surfaces other than grass.
• Never pick up or carry a trimmer by the power cord.
• Do not lean over the trimmer guard objects may be throw by the cutting line.
• Keep all nuts, bolts and screws tight to be sure the trimmer is in safe working condition.
• To avoid the risk of injury keep fingers and hands clear of the trimmer line on the leading edge of
the guard.
MAINTENANCE
• After use, disconnect the machine from the power supply and check for damage.
• When not in use store the machine out of the reach of children.
• Electric powered trimmers should only be repaired by an authorised repairer.
• Use only manufacturers recommended replacement parts and accessories.
The preparation for use, operation and maintenance of the tool:
- Read the instructions carefully;
- Be familiar with the controls and proper use of the equipment;
- Before use check the supply and extension cord for signs of damage or ageing,
- If the cord becomes damaged during use, disconnect the cord from the power supply
immediately.
DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY;
- Do not use the lawn trimmer (edge trimmer), if the cords are damaged or worn.
WARNING
- Cutting elements continue to rotate after the motor is switched off;
- Keep extension cords away from cutting elements;
- It is recommended that appliances should be supplied via a residual
current device (RCD) with a tripping current of not more than 30mA.
- This equipment must not be used for composting purposes (shredding)
as this could result in injury or damage to property.
4

Publicité

Table des Matières
loading

Table des Matières