LawnMaster GT1415 Guide D'utilisation page 10

ASSEMBLY
WARNING
Before assembly, make sure that the grass trimmer is switched off and
unplugged.
Fitting the guard (See Fig. 2 & Fig. 3)
1. Fit the debris guard onto the motor head as shown.
2. Fasten the debris guard with a screw and the Hex key.
WARNING
Never use the grass trimmer unless the guard is properly fitted.
Fitting the secondary handle (See Fig. 4 & Fig. 5)
1. Place the handle on the grass trimmer as shown.
2. Adjust the handle to the most comfortable position. Use the marking as a guide.
3. Pass the bolt through the secondary handle and the main handle.
4. Screw the nut into the other side of the bolt. Do not over tighten the bolt.
Fig. 2 Fig. 2 Fig. 2
Fig. 4
10
Fig. 3
Fig. 5