LawnMaster GT1415 Guide D'utilisation page 14

MAINTENANCE
Your grass trimmer has been designed to operate over a long period of tome with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
WARNING
Before performing any maintenance, switch off and unplug the tool.
• Regularly clean the ventilation slot in your grass trimmer using a soft brush or
dry cloth.
• Regularly clean the cutting line and spool using a soft brush or dry cloth.
• Regularly use a blunt scraper to remove grass and dirt from the underneath
of the guard.
Fitting a new spool of cutting line
• Unplug the grass trimmer
• Keep the tabs
① depress thumb tabs and remove the spool cover
③ Remove the empty. spool
• Remove any dirt and grass from the spool cover and housing
• Taking the new spool and push It into the boss in the spool cover. Rotate the spool slightly
until it is seated.
• Unclip the end of one of the cutting lines and guide the line into one of the eyelets ⑤. The
line should protrude approx. 4 inches from the spool cover.
• Unclip the end of the other cutting line and guide the line into the other eyelet. The line
should produce approx. 4 inches from the spool corner.
• Align the tabs ① on the spool cover with the cut outs ④ in the housing.
• Push the cover onto the housing until it snaps securely into place.
(See Fig. 15 & Fig. 16)
Fig. 15
14
② from the housing
④ from the spool cover .
Fig. 16