Publicité
Les langues disponibles
Les langues disponibles
Installation
Dirt and Scale Plug Pump and Pipes!
Use New Pipe for Best Results.
Pump
Body
Clean Flow!
1096 0697
Figure 1: No Dirt or Scale in Suction
Pipe
1100 0697
Figure 2: Foot Valve Must Work Freely
No Sags
Sags Allow Air Pockets
If Air Pockets Form, Water Won't Flow.
Keep Pipe Straight and Angled up to Pump.
1101 0697
Figure 3: No Air Pockets in Suction
Pipe
Compound Will
No Air Leaks
Damage Plastic.
in Suction Pipe.
If Air Flows
Water Won't
Use PTFE Tape
Figure 4: Suction Pipe Must Not Leak
All manuals and user guides at all-guides.com
BEFORE YOU INSTALL YOUR PUMP
NOTE: For proper performance, pump MUST be matched to ejector and
to well depth. Use shallow well installation for wells up to 25 ft depth to
water and deep well ejector for depths up to 130 ft.
Step 1. Long runs and many fittings increase friction and reduce flow.
Locate pump as close to well as possible: use as few elbows and
fittings as possible.
Step 2. Be sure well is clear of sand. Sand will plug the pump and void the
warranty.
Step 3. Protect pump and all piping from freezing. Freezing will split pipe,
damage pump and void the warranty. Check locally for frost pro-
From
tection requirements (usually pipe must by 12" below frost line and
Well
pump must be insulated).
Step 4. Be sure all pipes and foot valve are clean and in good shape.
Step 5. No air pockets in suction pipe.
Step 6. No leaks in suction pipe. Use PTFE pipe thread sealant tape to seal
pipe joints.
Step 7. Match pump to well.
IMPORTANT: Flow into well must at least equal flow out through
pump!
Step 8. Unions installed near pump and well will aid in servicing. Leave
room to use wrenches.
Step 9. Plug 1" drive port when installing on shallow well.
SHALLOW WELL/CENTRIFUGAL INSTALLATION
No ejector is used in this case, plug the smaller of the two inlet ports,
using the larger for the suction pipe. Refer to Figure 6 for installation tips.
Maximum depth to water for shallow well/centrifugal operation is 25 feet.
NOTE: To avoid pump overloading and motor failure, install a flow control
valve at the discharge to limit flow to 20 gallons per minute.
Deep well is more
Pipe Joint
than 25' (7.6M)
to water with
pump running.
Well
Well
Casing
Casing
Foot
Foot
Valve &
Valve &
Strainer
Strainer
Figure 5: Double Pipe Deep Well
1102 0697
Check
Valve
1" NPT
1" NPT
Plug
Deep well is more
Plug
than 25' (7.6M)
Shallow well is less
Shallow well is less
to water with
than 25' (7.6M)
than 25' (7.6M)
pump running.
to water with
to water with
pump running.
pump running.
Well
Casing
Foot
Foot
Valve &
Valve &
Strainer
Strainer
Figure 6: Cased Shallow Well
and Drive Point Shallow Well
4
1" NPT
1" NPT
Plug
Check
Plug
Valve
Be sure
Be sure
entire
entire
well
well
point is
point is
below
below
water.
water.
Drive
Drive
Coupling
Well
Coupling
Casing
Drive
Drive
Point
Point
822 0697
822 0697
Publicité
