Publicité
Les langues disponibles
Les langues disponibles
Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if
ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if
ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The label NOTICE indicates special instructions which
are important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
Make workshops childproof; use padlocks and master
switches; remove starter keys.
California Proposition 65 Warning
This product and related accessories
contain chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
WARNING
section of this manual and
motor nameplate.
supply.
Hazardous voltage.
Electrical Code, and local
Can shock, burn, or
codes for all wiring.
cause death.
Ground pump before
connecting to power
supply. Disconnect power
manual when connecting
before working on pump,
motor or tank.
motor to power lines.
All manuals and user guides at all-guides.com
To discharge motor capacitor, hold insulated handle
screwdriver BY THE HANDLE and short capacitor
terminals together. Do not touch metal screwdriver
blade or capacitor terminals. If in doubt, consult a
qualified
electrician.
motors are designed to operate at high temperatures. To
avoid burns when servicing pump, allow it to cool for 20
minutes after shut-down before handling.
Do not allow pump or any system component to freeze.
Freezing may damage system, leading to injury or
flooding. Allowing pump or system components to freeze
will void warranty.
Relief valve must be capable of passing full pump flow at
75 PSI.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
Wire motor for correct
voltage. See "Electrical"
Ground motor before
connecting to power
Meet National Electrical
Code, Canadian
Follow wiring
instructions in this
ELECTRICAL SAFETY
Capacitor voltage may be hazardous.
GENERAL SAFETY
Do not touch an operating motor. Modern
WARNING
Hazardous pressure!
Install pressure relief
valve in discharge pipe.
Release all pressure on
system before working on
any component.
2
Publicité
