Autosen AL010 Notice D'utilisation page 40

8.3 Explanation of the menu
For the factory settings please refer to the end of these instructions (→ 15 Factory
setting)�
Configuration for output 1
0v1
5 switching functions can be selected:
[Hno], [Hnc], [Fno], [Fnc], [OFF] → 10.2.3 Configure OUT1 / OUT2.
Configuration for output 2
0v2
5 switching functions can be selected:
[Hno], [Hnc], [Fno], [Fnc], [OFF] → 10.2.3 Configure OUT1 / OUT2.
Switch point for hysteresis function OUT1 / 2
5p1
Value at which the output with selected hysteresis function changes its
5p2 switching state (object nearer/farther than distance set)�
[SP1/2] is only active if [OU1/2] = [Hno] or [Hnc]
→ 10.2.5 Setting of the switch point for hysteresis function OUT1 / OUT2.
Switch points for window function OUT1
np1
Values at which the output with selected window function changes its
fp1 switching state (object present / not present between the distance "near"
and the distance "far")�
np2
[nP1/2] = switch point "near" / [FP1/2] = switch point "far"�
[nP1/2] / [FP1/2] are only active if [OU1/2] = [Fno] or [Fnc]
fp2
→ 10.2.9 Setting of the switch points for window function OUT1 / OUT 2.
Extended functions
ef
Press [ENTER] to open the submenu "Extended functions"
→ 10.3 Extended functions.
Restore the factory setting
re5
→ 10.3.3 Reset of all parameters to factory setting.
Delay for the switching outputs
d51
[dSx] = switch-on delay; [drx] = switch-off delay�
The output does not immediately change its switching state when the
dr1
switching condition is met but only after the delay has elapsed� If the
switching condition is no longer met after the delay has elapsed, the
d52
switching state of the output does not change�
[dSx] and [drx] are not effective if [OU1/2] = [OFF]
dr2
→ 10.3.1 Setting of the delay time for switching outputs.
40