Conrad Electronic WS 1600 Notice D'emploi page 53

All manuals and user guides at all-guides.com
Use the + - button to set the alarm to ON or OFF. („AOF" = OFF, „AON" = ON).
To confirm the set value and return to the normal display mode, press the SET button.
blinking
Note:
If a storm warning alarm is active, the downward weather trend arrow blinks. (Also
see the section „WEATHER TREND DISPLAY")
Leaving the manual setup mode
To leave the manual setup mode, you can press the ALARM or the HISTORY button
at any time during manual setup or wait for the automatic timeout. In both cases, the
device returns to the normal time display mode.
Setting the wakeup alarm
You can set the alarm with the ALARM and the SET buttons.
Press the ALARM button once. The ALARM symbol and the alarm time display
appear on the top right part of the LCD monitor.
Alarm time display
Alarm ON symbol
Press and hold the SET button for approx. 2 seconds. The hours of the alarm time
start blinking Set the hours of the alarm time with the buttons + - or MIN/MAX
Press SET to confirm your selection and to access the minutes. The minutes start to
flash.
Set the minutes of the alarm time with the buttons + - or MIN/MAX
Press ALARM for confirmation. Wait approx. 30 seconds until the display automati-
cally returns to the normal display mode.
In normal display mode, press the ALARM button once to return to the alarm setup
mode. Briefly press the SET button to set the alarm to ON or OFF. (The symbol ((( • )))
means that the wakeup alarm was set.)
Press the HISTORY button or wait approx. 30 seconds for the automatic return to
normal display mode.
51