MINN KOTA ULTREX Instructions D'installation page 24

ROUTING UNIvERSAL SONAR & -PILOT LINK CABLES
2
d. Align the pins of the Universal Sonar connector
plug from the Control Head with the matching
socket end of the appropriate Universal Sonar
Extension Cable for your fish finder. Firmly
push the connector plug into the socket of the
Universal Sonar connection. Twist the locking
collar until it is snug.
e. Connect the other end of your adapter plug to
your fish finder following the manufacturer's
instructions.
Routing Universal Sonar & i-Pilot Link Cables
Your trolling motor is pre-installed with a Universal Sonar transducer system. For compatibility and more information on
Universal Sonar, please visit minnkotamotors.com. Your trolling motor will also be pre-installed with either i-Pilot or i-Pilot
Link. To learn more about the GPS capabilities available with your i-Pilot or i-Pilot Link navigation system, please refer to the
corresponding Owner's Manual by visiting minnkotamotors.com.
Both the Universal Sonar and i-Pilot Link features require cables to be connected to an output device. These connections are
present on the trolling motor below the Control Head. The i-Pilot system does not need an external wired connection. If only one
connection is present, it is because your motor is equipped with the i-Pilot system. If only a single connection is present, it is to
connect the Universal Sonar. If two cables are present, one is to connect the Universal Sonar, and the other is to connect the
i-Pilot Link connection. Please follow the Minn Kota recommendations on routing the cables to optimize mobility and maximize
functionality. The routing will be the same regardless of the number of cables present. Use the following instructions to properly
route cables.
The Universal Sonar Cables are shielded to minimize interference. To protect this shielding the cables should not be pulled tight
against sharp angles or hard objects. If using cable ties, do not over-tighten. Any excess cable should be bundled in a loose loop
of no less than 4" in diameter.
To minimize trolling motor interference, ensure that the fish finder and trolling motor are powered by separate batteries. Please
refer to the Battery & Wiring Installation and Motor Wiring Diagram sections of this manual for correct rigging instructions.
i-Pilot Link Cable
24 | minnkotamotors.com
All manuals and user guides at all-guides.com
i
Eight Pin Connector
i-Pilot Link Cable from
Control Head
Locking Collar
Universal Sonar
Extension Cable
Locking Collar
NOTE:
If the cable length does not reach the desired
fish finder installation location, a 14.5' extension cable
is available (MKR-US2-11) (sold separately). Repeat
the connection process described above on both ends
to install this accessory.
Universal Sonar
Extension Cable
Locking Collar
Four Pin Connector
Universal Sonar Cable
from Control Head
Four Pin Connector
Universal Sonar Cable
from Control Head
©2016 Johnson Outdoors Marine Electronics, Inc.