ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
Orientate the Pedal Control Sleeve Assembly for a Starboard Mount
By default, the Pedal Control Sleeve Assembly is factory set so that when your Ultrex is installed on the port side of your boat, the
Pedal Control Sleeve Assembly points inboard. Should you choose to install your Ultrex on the Starboard side of your boat, it is
recommended that the default mounting location be changed so that the Pedal Control Sleeve Assembly points inboard.
Once the Mount is installed, the system is properly calibrated when the motor is deployed and the head of the motor and lower
unit align with the centerline or keel of the boat at the same time the top of the Foot Pedal is parallel to the deck of the boat.
Use the following instructions to change the mounting location of the Pedal Control Sleeve Assembly on the Steering Housing
and then properly align the head of the motor. If your motor was installed on the Port side of the boat, please disregard these
instructions and see the Indexing the Motor section of this manual.
1
a. Aligning the head of the motor before correcting
the placement of the Pedal Control Sleeve
Assembly will help calibrate alignment once the
assembly is in the recommended position. Turn
the Power Switch "on" and steer the motor so
that the Control Head is in line with the keel of
the boat. This can be done by steering the motor
with the Foot Pedal, turning the motor with
the remote, or manually turning the head of the
motor.
b. Leave the motor in the desired alignment and
turn the power to the Foot Pedal "off". Then
disconnect the power by removing the power
cables from the battery or turning "off" the
breaker if equipped.
©2016 Johnson Outdoors Marine Electronics, Inc.
All manuals and user guides at all-guides.com
1a
1b
Foot Pedal
Deck of Boat
Keel
Power Switch
WARNING
To avoid electric shock, make sure the motor is not
connected to a power source.
Pedal Control
Sleeve Assembly
minnkotamotors.com | 15