MINN KOTA ULTREX Instructions D'installation page 21

2
ITEM(S) NEEDED
#17 x 2
c. Determine the desired orientation of the
Stabilizer Bracket and attach it to the bottom of
the Steering Module. Place a Lock Washer (Item
#18) on each of the two 5/16" Cap Screws (Item
#17).
d. Use the 5/16" Cap Screws to secure the
Stabilizer Bracket to the Steering Module and
tighten with a 1/4" Allen wrench. Tighten to
10 ft-lbs.
3
e. Measure the proper length of the Aluminum Rod
by standing it, with the threaded end down, onto
the deck surface so that it sits vertically right next
to the Stabilizer Bracket.
f. Mark the Aluminum Rod with a pencil or marker
3/4" past the top of the Stabilizer Bracket.
CAUTION
Cutting the Aluminum Rod too short will cause
inadequate support of the mount. Lack of mount support
may cause damage.
g. Cut the Aluminum Rod with a Hack Saw at the
mark. Round the cut edge of the rod with a file or
sandpaper to remove any sharp edges.
©2016 Johnson Outdoors Marine Electronics, Inc.
All manuals and user guides at all-guides.com
#18 x 2
PLACING THE BOw-MOUNT STABILIZER
Steering Module
Lock Washer and
Cap Screw
Stabilizer
Bracket
Aluminum Rod
Stabilizer
Bracket
3/4"
Jam Nut
minnkotamotors.com | 21