MINN KOTA ULTREX Instructions D'installation page 19

ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
9
n. Re-tighten the two screws that fasten the Cable
Anchor to the top of the Steering Module using a
#2 Phillips screwdriver. Tighten to 25 in-lbs.
10
o. Using a #3 Phillips screwdriver, tighten the Cable
Tension Screw located at the base of the Toe
End of the Foot Pedal to 10 - 12 in-lbs until the
Steering Cables are under tension or re-tighten
the same number of turns as was used in step 4f.
CAUTION
Do not over tighten the Cable Tension Screw, as excessive
tension will cause damage to the unit.
p. Reconfirm that the Steering Cables are tight
and then carefully thread the Steering Motor
Connection Wire through the top of the Wrap
Drum Cover. The male plug comes from the Cable
Anchor through the opening at the bottom of the
Wrap Drum Cover. The wire with the female plug
that runs out the top of the Cable Gear should
also be pulled through the opening at the bottom
of the Wrap Drum Cover.
11
q. Place the Wrap Drum Cover down on top of the
Cable Anchor and align the screw holes on it with
the screw holes on the Cable Anchor. Make sure
the Wrap Drum Cover is nested securely on top of
the Steering Module and that the wires pass out
the top of the Wrap Drum Housing. Secure the
Wrap Drum Housing in place with the two screws
that were originally removed using a #1 Phillips
screwdriver. Tighten to 6 in-lbs.
©2016 Johnson Outdoors Marine Electronics, Inc.
All manuals and user guides at all-guides.com
10p
Cable
Tension
Screw
10q
Wrap Drum
Cover
CAUTION
Take care not to pinch the Steering Motor Connection Wire
while the Wrap Drum is set into place.
Screws
Wrap Drum Cover
Wires
Screws
Steering
Module
Cable Anchor
Toe End of
Foot Pedal
Steering Motor
Connection Wire
Cable Anchor
Steering
Module
minnkotamotors.com | 19