MINN KOTA ULTREX Instructions D'installation page 20

PLACING THE BOw-MOUNT STABILIZER
12
r. Reconnect the Steering Motor Connection Plug
and push it into the Wrap Drum Cover.
CAUTION
Wires and plug must not touch moving parts. Wires may
be damaged if caught in moving parts.
s. Orientate the wires connecting the Steering
Motor Connection Plug as noted so that the wires
do not touch moving parts.
t. Replace the Connector Cover.
Placing the Bow-Mount Stabilizer
The Bow-Mount Stabilizer Bracket is used to stabilize the Steering Module and reduce bouncing when the motor is stowed
and transported. Attention to detail is needed for successful installation of the stabilizer. We recommend to have the stabilizer
bracket installed by a qualified marine installer.
Adjusting the Aluminum Rod too tightly removes the end play needed for proper latch pin engagement and doing so could
prevent the mount from fully latching in the stowed position. Improper latching may cause damage. If installed correctly, the
tip of the Aluminum Rod should lift off of the boat deck about 1/4" without the mount unlatching. Cutting the Aluminum Rod
too short will cause inadequate support of the mount. Lack of mount support may cause damage.
1
ITEM(S) NEEDED
#11 x 1
a. Place the motor in the stowed position.
b. Un-thread the Aluminum Rod (Item #13) from the
Stabilizer Bracket (Item #12) by removing the Top
Bumper (Item #11) and unscrewing the bracket.
Also remove the Bottom Bumper (Item #15).
Keep the Jam Nut (Item #14) in place.
20 | minnkotamotors.com
All manuals and user guides at all-guides.com
CAUTION
#12 x 1
Steering Motor
Connection Plug
Steering Motor
Connection Wire
#14 x 1
#13 x 1
Top Bumper
Jam Nut
Stabilizer
Bracket
NOTE:
The Bow-Mount Stabilizer Bracket can be
installed on the left or right side of the Steering Module.
When mounting the bracket onto the Ultrex, the two
Nylock Nuts (Item #16) are discarded because the bolts
are secured directly into the Steering Module.
#15 x 1
#16 x 2
Bottom Bumper
Aluminum Rod
©2016 Johnson Outdoors Marine Electronics, Inc.