Publicité
Les langues disponibles
Les langues disponibles
7. Water - Filling
Step 1
Remove the stopper above the water tank.
Step 2
Fill the tank with approx. 16 liters of water
and then close the tank again with the
nozzle.
Attention:
Do not fill more than half of the tank, no more
than the mark! This would cause water to
leak out when the device is all set.
Tip:
Maximum
Fill a bucket with clean water. Place it on the
Filling level
tank unit. Insert the inlet rod of the pump into
the opening of the water tank. Place the
pump and the suction hose in the bucket
and suck in the water with 4 to 5 pumping
movements.
Due to the difference in altitude, the water
would run into the water tank by itself.
Publicité
