Burkert 8400 Mode D'emploi page 12

4 installation
Pt100
Measure
Measure compen-
sation
GND
All manuals and user guides at all-guides.com
4. electrical connection
Always ensure the power supply is switched off before working on the
device. All the cable plugs must be plugged out.
Use:
- a shielded cable with an operating temperature > +80 °C.
- a high quality voltage supply (filtered and regulated).
a 1-a fuse must be used for the power supply.
Wall-mounted temperature controller 8400
8400
V+
NPN output
PNP output
0 V
Receiver + power supply
(PLC for ex.)
1A
+
Load
NPN
PNP
Load
-