Modes Of Operation - MC Crypt DL-1101 Notice D'emploi

Installation
The light effect is attached to the ceiling or on a suitable crossbeam with its a mounting bracket.
• Install the mounting bracket at the top of the device with its thumb screws.
• Attach the effect beamer to the ceiling or on a suitable crossbeam using a mounting bracket. Make sure that
the device cannot swing freely.
• Secure the device with fastenings that are compatible with the fastening surface and suitable for carrying
the weight of the light effect device.
• Secure the installation with an additional suitable safety restraint cable or a safety net. The safety restraint
cable or the net must be designed to support the light effect in the event of a fault in the main support system.
• Set the desired angle of inclination and tighten the thumb screws well.

Modes of Operation

The following table shows the modes of operation. The DIP switches at the back of the device allow you to
set the mode of operation.
DIP switch > ON
1
1, 2
1, 3
- - -
10
22
Function
Operation with medium-speed movements (master device)
Operation with slow movements (master device)
Operation with fast -speed movements (master device)
Slave mode
Slave-mode (slave device reacts opposite to master device)