Installation - MC Crypt DL-1101 Notice D'emploi

Installation

The assembly and installation of the device must be carried out by a specialist who is
familiar with the hazards and the relevant regulations. The maintenance, operation and
commissioning of this product may only be carried out by qualified persons.
When choosing a location for your device, make sure to avoid impact, vibration, dust,
hot and cold temperatures and dampness. Furthermore, no powerful transformers or
motors must be used close to the device.
The light effect may only be installed in locations with an ambient temperature of no more
than 45°C. The maximum casing temperature is 60°C.
The device must be mounted out of normal reach.
Illuminated objects must be at least 0.5m away from the device's light emission source.
Easily flammable materials such as decorative fabrics must have a distance of at least
1 m to the device. Otherwise such objects may catch fire!
When mounting the product, make sure that the power cord is neither jammed nor
damaged by sharp edges.
During installation or service work, the area below the place of installation must be
cordoned off.
The area or equipment of installation must be designed in such a way that it can support
the tenfold rated load for at least one hour without being deformed permanently.
In addition, the device must be secured with a second independent safety fixture besides
the actual installation material when installed in an elevated position. If the main support
system fails, no part of the installation must fall down.
Observe all relevant regulations when mounting the device.
Acceptance test (by industrial use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be checked by an official expert.
A yearly inspection by a technical expert is required.
At least every four years, a quality inspection must be carried out by an official expert.
21