Setting the Operating Mode
General Menu Operation
Use the LED display and function buttons MENU, UP, DOWN and ENTER to set the operating mode.
•
Press the MENU button until the LED display shows the desired menu item.
•
Select the desired option with the UP and DOWN buttons.
•
Press the ENTER button to confirm your selection.
Symbol
Setting range
A001
A001-A512
A1 1
A1 1 - A1 9
A2 1
A2 1 - A2 9
A3 1
A3 1 - A3 9
A4 1
A4 1 - A4 9
A5 1
A5 1 - A5 9
A6 1
A6 1 - A6 9
S0 1
S0 2
The set values 1-9 for the automatic functions (marked A) determine motor speed (1=fast / 9=slow).
The LED display switches off if some time passes without any button being pressed. To reactivate it,
press ENTER.
Use as Stand-Alone Device or Master Device
In this operating mode, the effect light can be used as a single device (stand-alone) or a master device in master-
slave-operation.
•
Set the desired operating more as described above (but not the DMX control).
Use as Slave Device
•
Set the address A001 as DMX start address in the slave devices.
In master-slave operation, no external DMX controller must be connected to the master device.
Only one master-device must be defined in a mater-slave-chain. All other devices must be slave
devices.
Function
DMX control / Setting the DMX start address 001-512
Red permanent light with controllable motor speed
Green permanent light with controllable motor speed
Blue permanent light with controllable motor speed
Colour change effect (triple) with controllable motor speed
Colour change effect (seven-fold) with controllable motor speed
Fade-effect with controllable motor speed
Music-controlled colour change / motor stops if not triggered
Music-controlled colour change / motor continues if not triggered
25