10. Setting the Operating Modes
Use the function buttons MODE, SETUP, UP, DOWN and the display to set the operating mode.
The display switches off automatically after a few seconds without any button being pushed. Push any
button to activate it again.
a) Programme operation
•
Push the button MODE until the display shows "Prxx". "Pr" means that the device is in programme operation, "xx"
shows the selected programme.
•
The programmes "Pr01" to "Pr22" are available. These are different light effects for which parameters can be set.
•
Push the buttons UP or DOWN to select the desired programme.
•
Push the button SETUP to select the parameter to be changed.
•
Adjust the selected parameter with the buttons UP and DOWN.
Depending on the selected programme, different parameters may be set with the button SETUP.
Example:
•
Push the button MODE until the display shows "Prxx".
•
Select the light effect "Pr01" with the UP and DOWN buttons. This light effect shows a static colour.
•
Push the button SETUP and select the desired colour with the buttons UP and DOWN. The display shows a
combination of digits and letters to encode the colour.
•
Push the button SETUP and set the flashing frequency of the light effect with the buttons UP and DOWN. The
display shows "FS00" to "FS99" ("FS00" = no flashing effect, "FS99" = max. flashing frequency).
b) Automatic Operation
•
Push the button MODE until the display shows "AUTO".
•
Push the button SETUP to select the parameter to be changed.
"n001" to "n100" = Number of repetitions of the individual light effect sequences until the next sequence is
switched to.
"SP01" to "SPFL" = Light effect speed (slow to maximum speed)
FS00" to "FS99" = no flashing effect to max. flashing frequency
•
Adjust the selected parameter with the buttons UP and DOWN.
30