Setting The Operating Modes; Automatic Operation - MC Crypt LumiSTAGE 4/146-10 Notice D'emploi

7. Commissioning

7.4 Setting the Operating Modes

The function buttons and the display (1, 2, 3 and 4) set the operating mode.

Automatic operation

• Press the button MODE (1) until the display (4) shows "Axx". "A" means that the device is in automatic operation,
"xx" shows the selected function.
• Set the desired function with the buttons UP (2) or DOWN (3). The different functions are included in the following
list.
• The change is immediate.
• The light intensity is always 100% (full brightness).
In this operating mode, the device does not react to signals pending at the DMX IN (5) connection but
generates the corresponding DMX signals depending on the function selected (12-channel signals) at
the DMX OUT (6) connection. This makes it possible to control devices connected to DMX OUT (6) and
encoded as slave or slave reverse devices synchronously.
The last function set is stored even if this operating mode is left in between or the effect light is switched
off.
Functional overview:
Fade effect 0.05 Hz
A00 Single chase red/blue/green/yellow
A01 Single chase orange/pink/turquoise/light green
A02 Block chase red/blue/green/yellow
A03 Block chase orange/pink/turquoise/light green
A04 Fork chase red/blue/green/yellow
Fade effect 0.5 Hz
A10 Single chase red/blue/green/yellow
A11 Single chase orange/pink/turquoise/light green
A12 Block chase red/blue/green/yellow
A13 Block chase orange/pink/turquoise/light green
A14 Fork chase red/blue/green/yellow
32
A05 Fork chase orange/pink/turquoise/light green
A06 2Side chase red/blue/green/yellow
A07 2Side chase light orange/pink/turquoise/light green
A08 4C burst red/blue/green/yellow
A09 4C burst orange/pink/turquoise/light green
A15 Fork chase orange/pink/turquoise/light green
A16 2Side chase red/blue/green/yellow
A17 2Side chase orange/pink/turquoise/light green
A18 4C burst red/blue/green/yellow
A19 4C burst orange/pink/turquoise/light green