Carson Nitrobone Automatic Mode D'emploi page 11

b. Check 1...2...3...
Now you can switch on your car using the on/off switch located
on the radio box. Always turn the radio on before turning on
your car. Note: Always check your radio settings before running
your car!
Check to make sure your steering is centred. If it is not, use the
ST-TRIM knob to the left of the steering wheel (see page 8).
Turning left should make the car turn left. Right=right.
Racer Tip: Read the Radio manual for more advanced radio
setup information!
Now it's time to set the throttle neutral position. Remove the air
cleaner from the carburettor.
The opening on the carb slide should be open very little, from
1 - 1.5 mm to allow the engine to idle (picture 3). If it is open
more than this, the engine may rev higher than normal until
brakes are applied. This condition may wear out the brakes
and/or clutch shoes prematurely making the car difficult to
drive.
Use the TH-TRIM tab (picture 4) to move the servo arm into
the neutral position if necessary. While in neutral, the brakes
should not be set to "drag". Adjusting the collars with a
1.5 mm hexagonal wrench will change your drag brake settings.
Replace the air cleaner when everything is adjusted to your
satisfaction.
c. Final Preparations...
Assemble the fuel bottle. Fill the fuel bottle by compressing
it and then insert the spout into the fuel. Allow the bottle to
decompress and the suction will fill the fuel bottle. Fill the tank
by gently squeezing the bottle and ensure that the tank lid is
firmly shut when finished.
Picture 5
CARSON Automatic RTR: Nitrobone 50 010 3021 Stormracer 50 010 3022
All manuals and user guides at all-guides.com
Picture 3
Picture 4
Racer Tip 1:
Fuel will stay fresh longer if you store it in a cool, dark and dry
place.
Racer Tip 2:
To start the motor, use a fireproof glove!
1 - 1,5 mm
TH-Trimm
GB
11