Pentair MYERS PQP10 Notice D'utilisation page 6

tHE MOtOr iS SEt fOr 230 VOltS
WHEN SHiPPED.
To change the motor to use 115 volts:
1. Turn off power
2. Remove the back motor cover.
3. Use a screwdriver or 1/2" wrench and turn the
voltage selector dial counterclockwise until 115 shows
in the dial opening.
4. Reinstall the motor cover.
figure 12: changing the Voltage Setting
figure 13: Motor Set for 115 Volt Operation
Electrical
Hazardous voltage. Can shock, burn, or
cause death. Disconnect power to motor before
working on pump or motor. Ground motor before
connecting to power supply.
WiriNG
Ground motor before connecting to electrical
power supply. failure to ground motor can
cause severe or fatal electrical shock hazard.
Do not ground to a gas supply line.
to avoid dangerous or fatal electrical shock,
turn Off power to motor before working on
electrical connections.
Supply voltage must be within ±10% of
nameplate voltage. incorrect voltage can
cause fire or damage motor and voids warranty. if
in doubt consult a licensed electrician.
Use wire size specified in Wiring chart (Page 7).
if possible, connect pump to a separate branch
circuit with no other appliances on it.
Wire motor according to diagram on motor
nameplate. if nameplate diagram differs from
diagrams above, follow nameplate diagram.
1. Install, ground, wire and maintain this pump in
accordance with electrical code requirements.
Consult your local building inspector for information
about codes.
2. Provide a correctly fused disconnect switch for
protection while working on motor. Consult local or
national electrical codes for switch requirements.
3. Disconnect power before servicing motor or pump.
If the disconnect switch is out of sight of pump,
lock it open and tag it to prevent unexpected power
application.
4. Ground the pump permanently using a wire of the
same size as that specified in wiring chart (Page 7).
Make ground connection to green grounding
terminal under motor canopy marked GRD. or
6
.