Publicité
4-3. Troubleshooting
Trouble
No weld output from any welding
power sources; units completely
inoperative.
No weld output from one welding
power source.
OM-213 592 Page 20
Place line disconnect switch in On position (see Section 3-8).
Check and replace line fuse(s), if necessary, or reset circuit breakers (see Section 3-8).
Check for proper input power connections to rack (see Section 3-8).
Check fuses in applicable fuse block (see Section 4-2).
Check for proper input power connections to welding power source (see Section 3-5).
Check applicable welding power source according to its Owner's Manual.
Remedy
Publicité
