General Characteristics - Cembre B35-TC025 Notice D'utilisation

ENGLISH
BATTERY OPERATED HYDRAULIC CUTTING TOOL
WARNING
• Wear eye protection. Metal chips can fl y from blades when cutting.
• Do not cut short, free pieces of steel rod or rope as they may fl y off dangerously, causing
injury to the operator or persons nearby.
• Inspect the blades before each use. Do not use damaged blades.
• Damaged blades can break and cause injury or damage to the tool.
• Work in a clean, uncluttered area. Keep persons away from immediate work area.
• Use this cutting tool for the manufacturer's intended purpose only.
• Do not cut live cables or conductors.

1. GENERAL CHARACTERISTICS

TOOL TYPE:
Application range:
Max. cutting diameter mm (inches):
Rated operating pressure bar (psi):
Dimensions LxWxH mm (inches):
Weight with battery kg (lbs):
Motor Volt DC:
Battery type CB9620H Volt / Ah:
Battery charger supply Volt / Hz:
Recommended oil: AGIP ARNICA 22 or ESSO INVAROL EP22 or equivalent.
Safety:
Operating temperature:
Acoustic Noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L is equal to ............................................................................. 66,8 dB (A)
pA
– The maximum value of the weighted acoustic displacement
pressure C at the work place L is .....................................................................< 130 dB (C)
pCPeak
– The acoustic power level emitted by the machine
L is equal to ............................................................................................................... 75 dB (A)
WA
Risks due to vibration (Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests carried out in compliance with the indications contained in UNI ENV 25349 and UNI EN 28662
part 1 st Standards, and under operating conditions much more severe than those normally found,
certify that the weighted root mean square in frequency of the acceleration the upper limbs
are exposed to for each biodynamic reference axis does not exceed 2.5 m/sec
B35-TC025 B35-TC025A
suitable for cutting steel ropes,
copper and aluminium conductors
25 (1)
450 (6,500)
377 x 114 x 66 (14,8 x 4.5 x 2.6)
3.0 (6.6)
9.6
9.6 / 2.0 Ni-MH
220 - 240 / 50 - 60 120 / 50 - 60
the tool is equipped with a maximum pressure valve.
-15°C to +40°C (+5°F to +104°F)
2 .
86
3 32
66
26
27
48
39
41
42
40
19
16
FIG. 7
42
46
47
87
50
49
66
FIG. 8