Publicité
Les langues disponibles
Les langues disponibles
Operating manual
CONNEXION AU VÉHICULE
END OF CHARGE
The charge can be stopped at any time by pressing
Following a voluntary stop, some vehicles have a delay of up to one minute before allowing the charge
to be restarted or changed. Wait until
locked by the vehicle, no manipulation is possible.
LIST OF AVAILABLE OPTIONS
Adaptor
Schuko
Swiss T13
CEE 32 Single-phase
CEE 16 Three-phase
...
12
Translation of the original
instructions
Once the appropriate charge setting has been selected, connect the device to the
vehicle. The charger shows
The charge will then start automatically after a few seconds. The display will show
(charging in progress).
If charging has been delayed, the display shows alternately
time
until charging begins. It will indicate
flashes on the display. As long as it is fixed, the charger is
When the vehicle is fully charged, the charger will show
If a vehicle decides to relaunch the charge, the charger will automatically restart itself.
Remove the charging cable from the vehicle.
Disconnect the device from the power supply.
Limitation
10 A
Single-phase
8 A
Single-phase
32 A
Single-phase
16 A
Three-phase
...
SUPER PRO SMART EV CHARGE
on the display (connected).
for 3 seconds.
Network
Power
2.3 kW max
1.8 kW max
7.4 kW max
11 kW max
...
and the remaining
when charging is in progress.
on the display.
...
Publicité
