GYS SUPER PRO SMART EV CHARGE Manuel D'utilisation page 11

Operating manual
CHOICE OF CHARGE CURRENT
+
Setting up a delayed charge
You can set a delayed start to the charge (off-peak/peak hours).
This process must be carried out before confirming the charge rating.
+
Memorising the charge rating
This function should only be considered if the electrical installation is suitable.
The charging cable must be disconnected from the vehicle.
The settings can be saved in the unit's memory so that they are not lost in the event of a power failure. After disconnecting,
the charger will automatically restart with the memorised charging current.
Translation of the original
instructions
Connect the unit to the power supply.
The cable automatically detects the type of socket to which it is connected, and regu-
lates the current accordingly.
Eg: if a 16A single-phase power outlet is detected upstream of the charging cable,
then the maximum current setting will be 16A.
However, it is possible to charge the vehicle with a lower amperage (6-8-10-13 A)
if the electrical supply network requires it.
When the charger is switched on, select the charging current with the arrows
The charger always switches on with a default charging current of 10 A.
Press to confirm the desired current (if there is a calibration error, press
seconds and then repeat the process).

The display alternates between the selected current rating, and the "Ready" message.
The charger is now set up, and ready to be connected to a vehicle.
Press the «Current/Delay» button
Then use the arrows
hours, adjustable in hourly increments). Then press
After selecting & confirming the desired rating, press & hold
simultaniously. The LEDs
on the display.
To delete the stored data, repeat the same process of pressing and holding for
3 seconds. The LEDs
the screen.
. The Delay LED will light up.
to set the desired time delay (can be set from 1 to 24
& flash, and the «Storage» message appears briefly
& flash, and the «Clear» message appears briefly on
SUPER PRO SMART EV CHARGE
to confirm.
for 3 seconds
.
for 3
11