Dismantling The Machine; Demolishing The Machine; Disposing Of Harmful Substances - OEM HENERGO HV/45 E-1 Mode D'emploi Et D'entretien

G45
Dismantling - Demolition - Disposal
Chapter 7

7.1 - DISMANTLING THE MACHINE

Proceed by complying with the instructions given in
the "Installation" chapter, working in reverse order, if
the machine must be dismantled and then moved to
another site.
DANGER
Before disassembling the machine or demounting
some machine components, disconnect the power
supply.
The machine assembling shall only be carried out
by skilled and authorized personnel.
ATTENTION
In case it is necessary to disassemble the machine
or demount some machine components in a diffe-
rent way in comparison with the written instruc-
tions, Company manufacturer or its Agent shall be
contacted - see addresses on the third page of this
publication.

7.2 - DEMOLISHING THE MACHINE

To protect the environment, please
proceed in compliance with the local
laws in force.
When the machine can no longer be
used or repaired, please proceed with
recycle and disposal.
Electrical equipment cannot be disposed of as ordi-
nary urban waste: it must be disposed of according
to the special EU directive for the recycling of electric
and electronic equipment.
The electrical equipment is marked with a pictogram
of a garbage can inside a barred circle. This symbol
means that the equipment was sold on the market
after August 13, 2005, and must be disposed of
accordingly.
Due to the substances and materials it contains,
inappropriate or illegal disposal of this equipment, or
improper use of the same, can be harmful to humans
and the environment. Improper disposal of electric
equipment that fails to respect the laws in force will be
subject to administrative fi nes and penal sanctions.
ATTENTION
Consult the next paragraph when disposing of
harmful materials (lubricants, solvents, coating
products, etc.).

7.3 - DISPOSING OF HARMFUL SUBSTANCES

Consult the provisions established by the Standards
in force in each individual country before disposing of
such substances.
ATTENTION
Any improper use by the Customer before, during
or after scrapping and disposing of the parts of
the machine, in respect of the construction and
application of the applicable regulations, shall be
the customer's responsibility.
EN - 25