Publicité
Les langues disponibles
Les langues disponibles
EN
Synchronising Cooking Zones
Two functions are used to synchronise the
cooking zones:
•
SMART FINISH function – for two dif-
ferent foods that have different tem-
perature and cooking time settings,
but should be ready at the same time.
•
MATCH COOK function – for larger
quantities of a food or for different
foods with the same temperature and
cooking time setting.
L
It is not possible to synchronise
the cooking zones subsequently
while the device is operating.
Stand-By Mode
When the
button (9) is pressed, the
control panel (2) is activated. If the device
is not operating and no button is pressed
for 5 minutes, the device switches to
stand-by mode.
TIPS
•
Generally no oil or only a small amount
of oil (2 to 3 teaspoons) is required for
preparing food.
•
Very light pieces of food could be
swirled around by the circulating air.
If necessary, we recommend sticking
them together with toothpicks or
a similar object.
•
The cooking time is dependent on the
size and quantity of the food and on
the temperature. However, in gen-
eral the cooking time is shorter than
in a conventional oven. Start with a
shorter cooking time and gradually
increase it if required.
•
Mix the food around from time to
time or turn it with tongs to obtain an
even cooking result.
•
Check the condition of the food in be-
tween times and, if it is cooked, switch
off the device, even if the programme
has not yet finished.
20
11339_Inlay_DE-EN-FR-NL_A5_V1.indb 20
11339_Inlay_DE-EN-FR-NL_A5_V1.indb 20
SET-UP AND CONNECtION
Please Note!
■
Check the device and the connecting
cable for damage each time before
putting it into operation. The device
should only be used when it is un-
damaged and in working order.
■
Never place the device on a soft
surface. The ventilation openings on
the bottom of the device must not be
covered.
■
Ensure there is sufficient clear space
on all sides. Do not place the device
below kitchen wall units or similar
cupboards. The rising steam could
cause damage to them!
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces (e.g. of the
device).
1. Place the device on the kitchen unit or
another dry, clean, flat and heat-re-
sistant work surface. Ensure there is
sufficient clear space on all sides (at
least 20 cm to the sides and 50 cm
above).
2. Fully unwind the connecting cable
and plug the mains plug into a plug
socket.
09.12.2022 10:53:09
09.12.2022 10:53:09
Publicité
