Angelo Po 191BR1GA Manuel D'utilisation Et D'installation page 59

2 - Undo the screws (D) and remove the control
panel (E).
3 - Undo the screws (F) to remove the lid (G).
4 - Connect the circuit-breaker (A) to the terminal
board (H) of the appliance as shown in the dia-
gram and in the electrical system diagram at
the back of the manual.
Use a flexible cable with at least type H07RN-F
characteristics, rated for an operating tempera-
ture of at least 80°C.
5 - Tighten the cable gland (L).
Important
When connecting, take care to connect the
neutral and earth lines.
6 - Fit the lid (G) and secure it with the screw (F).
7 - Replace the control panel (E) on completion of
the operation.
CONVERSION OF ELECTRICITY SUPPLY (291BR1GA - 291BR2GA-291BR3GA)
The appliance is supplied at an operating voltage
400V/3N (indicated on the sticker applied to the da-
taplate); conversion to 230V/3 can be carried out as
described below.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
1 - Undo the screws (A) and remove the control
panel (B).
F
H
A
- 23 -
G
L
IDM-39616001900.tif
B A
IDM-39616201200.tif
English
IT
GB
DE
FR
ES