Angelo Po 191BR1GA Manuel D'utilisation Et D'installation page 47

SWITCHING THE BURNER ON AND OFF
Lighting
Important
Before proceeding with this operation
check that the well is not raised and resting
firmly on fixed part of appliance.
1 - Turn on the gas supply tap.
2 - Turn the knob (A) clockwise (pos. 1) to turn on
the electricity supply.
The mains light (C) comes on.
3 - Press the knob (B) and turn it anti-clockwise
(pos. 3) to light the pilot light.
Keep the knob pressed for about 15 sec. to
prime the thermocouple.
4 - Press the knob (B) and turn it anti-clockwise
(pos. 4) to light the burner.
5 - Turn the knob (A) clockwise (pos. 1) to the tem-
perature required.
The temperature light (D) comes on. The light
goes out once the temperature is reached.
Turning off
1 - Press the knob (B) and turn it clockwise (pos. 5)
to turn off the burner.
The pilot light will remain on to allow the burner
to be re-lit.
2 - Press the knob (B) and turn it clockwise (pos. 6)
to turn off the pilot light.
3 - Turn the knob (A) clockwise (pos. 2) to turn off
the electricity supply.
The mains light (C) goes out.
4 - Turn off the gas supply tap.
5 - Cut off the mains electricity supply using the ap-
pliance's master switch.
A
3
B
6
- 11 -
A C D
1
2
IDM-39616000700.tif
B
4
5
IDM-39616000800.tif
English
IT
GB
DE
FR
ES